IUVA Fact Sheet on COVID-19
Facts on UV and COVID-19
Can UVC help prevent COVID-19 transmission by reducing contamination?
- UVC disinfection is often used with other technologies in a multibarrier approach to ensure that whatever pathogen is not “killed” by one method (say filtering or cleaning) is inactivated by another (UVC). In this way UVC could be installed now in clinical or other settings to augment existing processes or to shore up existing protocols where these are exhausted by excessive demands due to the pandemic.
- UV light, specifically between 200-280nm [i] (UVC or the germicidal range), inactivates (aka, ‘kills’) at least two other coronaviruses that are near-relatives of the COVID-19 virus: 1) SARS-CoV-1 [ii] and 2) MERS-CoV [iii] [iv] [v]. An important caveat is this inactivation has been demonstrated under controlled conditions in the laboratory. The effectiveness of UV light in practice depends on factors such the exposure time and the ability of the UV light to reach the viruses in water, air, and in the folds and crevices of materials and surfaces.
- COVID-19 infections can be caused by contact with contaminated surfaces and then touching facial areas (less common than person-to-person, but still an issue) [vi]. Minimizing this risk is key because COVID-19 virus can live on plastic and steel surfaces for up to 3 days [vii]. Normal cleaning and disinfection may leave behind some residual contamination, which UVC can treat suggesting that a multiple disinfectant approach is prudent. UVC has been shown to achieve a high level of inactivation of a near-relative of COVID-19’s virus (i.e., SARS-CoV-1, tested with adequate dose of 254nm UV while suspended in liquid)[viii]. IUVA believes similar results can be expected when treating COVID-19’s virus, SARS-CoV-2. However, the key is applying UVC in such a way that it can effectively reach any remaining viruses on those surfaces.
- IUVA also concurs with CDC guidance to hospitals that the germicidal effectiveness of UVC is influenced by the UVC absorbing properties of the suspension, the surface or aerosol that the organism is in; by the type or action spectra of the microorganism; and by a variety of design and operating factors that impact the delivered UV dose to the microorganism (https://www.cdc.gov/infectioncontrol/guidelines/disinfection/).
- IUVA recognizes that in the cases where the UVC light cannot reach a particular pathogen, that pathogen will not be disinfected. However in general, reducing the total number of pathogens reduces the risk of transmission. The total pathogenic load can be reduced substantially by applying UV to the many surfaces that are readily exposed, as a secondary barrier to cleaning, especially in hurried conditions. This would be a relatively straight-forward matter of illuminating the relevant surfaces with UVC light, for example the air and surfaces around/in rooms and personal protective equipment.
Are UVC disinfection devices safe?
Like any disinfection system, UVC devices must be used properly to be safe. They all produce varying amounts of UVC light in wavelengths of 200nm-280nm. This UVC light is much “stronger” than normal sunlight, and can cause a severe sunburn-like reaction to your skin, and similarly, could damage the retina of your eye, if exposed. Some devices also produce ozone as part of their cycle, others produce light and heat like an arc welder, others move during their cycles. Hence, general machine-human safety needs to be considered with all disinfection devices, and these considerations should be addressed in the operations manual, in the user training, and appropriate safety compliance.
Are there performance standards and UVC validation protocols for UV disinfection devices?
Given the wide array of UVC devices marketed for disinfection of air, water and solid surfaces, the lack of uniform performance standards and the highly variable degree of research, development and validation testing that is performed on different devices, the IUVA urges consumers to exercise caution when selecting equipment and look for evidence of third party testing as well as certification of device materials and electrical components by well-known organizations such as NSF, UL, CSA, DVGW-OVGW or other international requirements as applicable. For UVC devices designed to inactivate air and solid surfaces in the healthcare industry, members of IUVA are working diligently with other national standards organizations in the lighting and healthcare industry to develop disinfection testing standards [x]. The goal is to develop guidance that will help healthcare providers world-wide choose the best possible technologies for their institutions to use in the fight against multiple drug resistant organisms and other pathogens [xi], like the COVID-19 virus.
IUVA will soon post a website dedicated to UV and COVID-19, please email us at [email protected], if you would like for us to send you alerts on website postings and other IUVA activities. Visit the IUVA website at https://www.iuva.org/
[i] “Miscellaneous Inactivating Agents – Guideline for Disinfection and Sterilization in Healthcare Facilities (2008);” Centers for Disease Control and Prevention, National Center for Emerging and Zoonotic Infectious Diseases (NCEZID), Division of Healthcare Quality Promotion (DHQP) (https://www.cdc.gov/infectioncontrol/guidelines/disinfection/disinfection-methods/miscellaneous.html)
[ii] “Large-scale preparation of UV-inactivated SARS coronavirus virions for vaccine antigen,” Tsunetsugu-Yokota Y et al. Methods Mol Biol. 2008;454:119-26. doi: 10.1007/978-1-59745-181-9_11.
[iii] “Efficacy of an Automated Multiple Emitter Whole-Room Ultraviolet-C Disinfection System Against Coronaviruses MHV and MERS-CoV,” Bedell K et al.ICHE 2016 May;37(5):598-9. doi:10.1017/ice.2015.348. Epub 2016 Jan 28.
[iv] “Focus on Surface Disinfection When Fighting COVID-19”; William A. Rutala, PhD, MPH, CIC, David J. Weber, MD, MPH; Infection Control Today, March 20, 2020 (https://www.infectioncontroltoday.com/covid-19/focus-surface-disinfection-when-fighting-covid-19)
[vi] “Preventing the Spread of Coronavirus Disease 2019 in Homes and Residential Communities”; National Center for Immunization and Respiratory Diseases (NCIRD), Div. of Viral Diseases (https://www.cdc.gov/coronavirus/2019-ncov/hcp/guidance-prevent-spread.html)
[vii] “New coronavirus stable for hours on surfaces”; CDC (extracted from N van Doremalen, et al. Aerosol and surface stability of HCoV-19 (SARS-CoV-2) compared to SARS-CoV-1.The New England Journal of Medicine. DOI: 10.1056/NEJMc2004973 (2020)) (https://www.nih.gov/news-events/news-releases/new-coronavirus-stable-hours-surfaces).
[viii] “Inactivation of SARS coronavirus by means of povidone-iodine, physical conditions and chemical reagents;” Kariwa H et al.Dermatology 2006; 212 (Suppl 1): 119 (https://www.ncbi.nlm.nih.gov/pubmed/16490989)
[ix] “Ultraviolet Radiation and the Work Environment (Revised. See: 74-121),” The National Institute for Occupational Safety and Health (NIOSH), Page last reviewed: March 29, 2017 (https://www.cdc.gov/niosh/docs/73-11005/default.html)
[x] “Pathway to Developing a UV-C Standard – A Guide to International Standards Development”, C. Cameron Miller and Ajit Jillavenkatesa, IUVA News / Vol. 20 No. 4, 2018
[xi] “Healthcare Associated Infections Workshop Advances Development Of Ultraviolet Disinfection Technologies,” IUVA Press Release, dated 24 Jan 2020 4:14 PM (http://iuva.org/Projects-Articles-Repository/8672736)